Nice post pics
What did you do to your FX / QX70 today?
- Thread starter pmanliu
- Start date
Nice post pics
Sure, why not.
Here are a couple, before and after, it's just enough for me, I don't like them out too far. I will post a couple more on my Garage.
BEFORE Spacer
AFTER Spacer Install
Would you guys trust these? Thinking about getting these instead of painting my hats to hold me over til I can afford a BBK.
http://item.mobileweb.ebay.com/viewitem?index=0&sbk=1&nav=SEARCH&itemId=390545875098
http://item.mobileweb.ebay.com/viewitem?index=0&sbk=1&nav=SEARCH&itemId=390545875098
Those are Kinetic rotors. They are OK.
• •
• •
Thanks Zebra! I just ordered them so we will see how they look. I think my GTRs HAVE to at least have these behind them.
---------- Post added at 09:32 PM ---------- Previous post was at 09:31 PM ----------
Should I use new pads with them or can i just replace the rotors?
---------- Post added at 09:32 PM ---------- Previous post was at 09:31 PM ----------
Should I use new pads with them or can i just replace the rotors?
Should have gotten my GTR's mounted today. Instead my tires did not come, so hopefully tomorrow. If it is not tomorrow I am going to drive to the discount tire and absolutely flip shit because the tires were meant to be there tuesday.
On the plus side, I picked up a set of gold Blackworks racing lug nuts and a set of gold blackworks racing fender washer kits.
The plan is to do a gold BBK in the near to immediate future. I definetly missed out on Zebra's BBK for sale. But unfortunately I probably would have been killed if I had bought them then.
On the plus side, I picked up a set of gold Blackworks racing lug nuts and a set of gold blackworks racing fender washer kits.
The plan is to do a gold BBK in the near to immediate future. I definetly missed out on Zebra's BBK for sale. But unfortunately I probably would have been killed if I had bought them then.
Dyna mat'd the trunk while I had everything out. Now off to the dealer about the wiring harness.
---------- Post added at 01:50 PM ---------- Previous post was at 06:41 AM ----------
Changed out the rear reflectors to the lighted version. Wired them thru the 4-pin trailer harness.
---------- Post added at 01:50 PM ---------- Previous post was at 06:41 AM ----------
Changed out the rear reflectors to the lighted version. Wired them thru the 4-pin trailer harness.
With the harness, you do not have to remove the tail lights at all. It is all done from inside the vehicle. You have to take out the back interior to access the wiring harness. And you have to drill a hole for the wiring to end up outside. Other than that, it was a piece of cake.
Can someone link me to the lowest price on the harness?
I need one for first gen
