Is there a specific way the filter needs to be placed?
I remember reading somewhere about the raised tab things on the inside, and the filter is supposed to sit on top? Is that true?
If it is, your DIY write up will be tested after work for a redo.
Even though this is for FX 09+, see step 13. I think that's what was meant.
///11009
Thanks for the write up, it took no longer then 15 mins. I ending up using the Fram Fresh Breeze filter. I didn't disconnect any wires. Glove box was hanging sitting on my cordless drill box. Just maneuvered the glove box when removing the old filter and sliding the new filter in at an angle.
However, I had to realign the filter again as shown in the link above STEP 13. Make sure the filter was sitting above the 4 tabs on the plastic cover. I was wondering why the white plastic cover was pressing up against the filter and a tight fit. DUHH!!!
