What did you do to your FX / QX70 today?

just curious, how come on the screen your front camber is out specs, also rear camber and toe too. but on the print out, the before you only got L/F toe and total toe is out of specs?
 
Man that sucks. I'm looking at running smaller tires when I replace mime in the next month, but the thought of my wife mangling the wheels in this same fashion is making me think twice. :eek:
 
I was trying to park at mall and was distracted by my little cousin in the back seat and got too close to the curb. What made it worse was there was a water drain in my parking spot and it made the curb higher and that's how the scratch got that high on the spoke.

zebra555 said:
Ouch... Were they powder coated?

• •
Click to expand...

Yes they are

Sent from my HTC 2
 
Finally changed the plugs at 46k to Denso Iridiums. New plugs made a decent difference. Also pulled the cheesy JWT heat shield and factory scoop. Much cleaner look and no difference in drivability. Tomorrow I'm wrapping the windshield trim in black brushed vinyl. The clear is peeling in one spot.
 
@ JC - ouch. That hurts man. I remembered when we were out for dinner while visiting PA, I got distracted by an elderly lady who was hesitating a turn at the parking lot and I end up not noticing the low curb and scratched one rim. I was beyond pissed that we did take out order instead of dining in.

---------- Post added at 06:34 PM ---------- Previous post was at 06:31 PM ----------

Cleaned my messy KP tech module wirings under the hood by installing heavy duty wire harness jackets on the wires. Tucked the wires well and secured with zip ties. Finally fixed my busted horns, removed the PIAA aftermarket horns and installed OEMs.
 
You must log in or register to reply here.
Back
Top