k3fir
Member
- Location
- san francisco
2insane87:
did u go to the dealer to change them?
how much did it cost?
did u go to the dealer to change them?
how much did it cost?
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
Vdc off , Slip and Service Engine Soon Lights On!
- Thread starter insane87
- Start date
k3fir
Member
- Location
- san francisco
2insane87:
i had exactly the same.
i ran the check engine codes today - it said i just need to change the camshaft sensor
i had exactly the same.
i ran the check engine codes today - it said i just need to change the camshaft sensor
shumby
Member
- Location
- Edmonton Alberta
had to change the cam sensor on my old Maxima. easy to change pricey little part thought considering it is only a little magnetic pick up.
- Location
- Riverside, CA
Brake pads or fluid is not a warranty covered item.
I think that's common sense. I was implying that it is most likely something else other than pads or fluid.
We have just been getting VDC and Slip light on with no check engine light. It only happened twice now when it's a little colder in the morning. The lights go away after a short drive. Strange...
The stealership suggested I add brake fluid since it might be low. I check the fluid and it was fine, but I added some more to to it off. I hope it doesn't come back on.
k3fir
Member
- Location
- san francisco
2mongolian: i had the same problem as well. evrth went away after i changed the break pads
- Location
- Riverside, CA
The stealership said it was most likely the fluid or pads.... My pads were brand new, but I think it might have been the fluid.
mjstriff
Member
- Location
- dublin, california
just had this same problem yesterday...diagnostics were run on the car and everything is fine...they said the cam sensor will malfunction due to low or dirty oil as well..i added some oil and everything is fine...just fyi so we dont all start replacing the sensor
Yusuf
Member
just had this same problem yesterday...diagnostics were run on the car and everything is fine...they said the cam sensor will malfunction due to low or dirty oil as well..i added some oil and everything is fine...just fyi so we dont all start replacing the sensor
Did adding the oil do the trick? I have the infamous check engine light on as well. (will go to Autozone ASAP to check the codes). I have a 2005 @ 81k mi (just bought the thing).
Share: