MAP light LED bulb replacement DIY

R

rjtudy

Member
New to the forum, haven't seen a better bunch of knowledgable cool peeps anywhere else.

I just ordered replacement LED bulbs for my 2010 FX35 but before I go messing around with a screw driver I wanted to know if anyone here has taken apart their front map lights on the 2nd gen fx? Not sure where to poke and prod...

Many thanks!
 
Welcome to the Scene. Someone recently asked this same question.

///10458
 
Damn sorry guys! If I knew an LED swap DIY was needed I wouldn't of made a DIY when I did mine lol. But here's my advice:

There is no place to insert the screw driver. I used a flat headed razor blade wedged in between to do it. But I wrapped it in electrical tape to protect from scratching something. Also use painters tape around the edges to protect the surrounding surfaces. It may seem like the cover doesn't want to pop off, but trust me it will. It just takes a little bit of elbow grease and patience.

Check out my mods thread in the lighting section. Mine came out great:

cimg1930i.jpg



cimg1931g.jpg


cimg1933b.jpg



cimg1937r.jpg



cimg1936iz.jpg
 
Last edited by a moderator:
You must log in or register to reply here.
Back
Top