Will 22mm Ichiba V2 spacers clear studs?

[HaiRolla]

I did some searches in here and found that 25mm and larger version 2 ichiba spacers will bolt on and clear the studs for stock wheels to mount flush. 20mm 15mm etc will have to have the studs cut or ground down but no mentions of 22mm spacers. Has anyone used these for wheels like stockers that are flush on the mounting side?

I would like to stay with direct bolt on spacers w.o cutting original studs. I know 25mm and 22mm arent a big difference but i cant decide between 20 or 25mm spacers and these seem to "meet in the middle." Thanks
http://ebay.com/itm?itemId=190577039098

 

[soonster]

From what I remembered, the 20mm spacers will clear oem studs without trimming. Not 100% sure, but I'm sure others will chime in.

 

[la_fx35]

20 mm spacer will not clear stock studs.

 

[HaiRolla]

Thanks, big question is if the 2mm on the 22mm spacers going to allow the clearance I need?

 

[soonster]

Are you using them on oem 20's? If so, those wheels have slotted spacing within.

 

[GEE50FX]

He said he was using the stock wheels, so as Soon said, the studs will sit in the recesses of the stock wheels

 

[la_fx35]

With stock 20's; 25 mm spacer all around will give a very good looking stance. I feel 30 mm in front will be perfect.

 

[HaiRolla]

OK, thanks guys. The stockers do have a grove in the back of the wheel between every stud but I wasn't sure if that was deep enough. I was reading an old thread (https://www.infinitiscene.com/searc...-Installed-Spacers-amp-Major-Vibration-40-MPH!) that said that the recessed slots aren't deep enough on he stock wheels for 20mm / 15mm spacers. I'll just get the 25mm ones be safe. Thanks for all the help!