The Beast - FX45 :: 2004 Infiniti FX45

Overview Discussion
I can tell you right now, they are shorter LOL, so I will see if I can take them apart and just move the chrome pieces onto the plastic housing. The mounting holes are same for both, but the chrome one is a tad shorter and more curved towards the end. Had no idea Infiniti went through a trouble of redesigning the entire panel insert just for that.
 
Just picked her up. She is officially low. Will take better pix tomorrow, was a long day and I am seeing double lol.

bu9uqyse.jpg
upujaquq.jpg
 

Attachments

  • bu9uqyse.jpg
    bu9uqyse.jpg
    175.8 KB · Views: 33
  • upujaquq.jpg
    upujaquq.jpg
    158.7 KB · Views: 28
Nice...what springs did you go with??

---------- Post added at 05:19 PM ---------- Previous post was at 05:15 PM ----------

Nice...what springs did you go with??

And what happened to the rest of your AVS visors on that side??!! lol
 
H&R.

Painted my quarter panel window, so took the rubber seal off the rear door allowing the paint to cure. Will go back on the car tomorrow.

Good eye
 
Thanks guys for the comments and thanks for constantly pointing it out, glad I listened:)

---------- Post added at 07:00 PM ---------- Previous post was at 06:59 PM ----------

The drop actually shows off the flush look with spacers so much better now.
 
Unless Adam was looking for the old caddie boat floaty ride quality then we would hear about his complaint. :laugh:
 
Decided to change up my radio knobs and since there isn't anything good for Gen1 in this department, again had to DIY :)

5avezezy.jpg
ezase2ap.jpg
 

Attachments

  • 5avezezy.jpg
    5avezezy.jpg
    148.4 KB · Views: 26
  • ezase2ap.jpg
    ezase2ap.jpg
    159.1 KB · Views: 28
You must log in or register to reply here.
Back
Top