taking apart headlight help

[Viperi]

i read the diy. took off all the lights and wires. but there is a yellow wire wit ha spade connector and two red wires that hooked up to a clip still attached to a component. How d oi take that component out or the wires? do i just leave them in when i bake it? ALso what bout the light gray component? I can twist it off but i cant get it off. its connected inside by this blue plastic part

 

[AeroBFA]

Can you provide pictures? I'm vaguely aware of how the headlight components work and look like from handling them, but a picture would help you get more replies.

 

[la_fx35]

i read the diy. took off all the lights and wires. but there is a yellow wire wit ha spade connector and two red wires that hooked up to a clip still attached to a component. How d oi take that component out or the wires? do i just leave them in when i bake it? ALso what bout the light gray component? I can twist it off but i cant get it
off. its connected inside by this blue plastic part

As I remember, there is one wire that you can't take off. No problem with braking with it on. I have brake three sets of head lights without any parts melted.:smile (2):
Just make sure once the oven reach 300 degree (that's the setting I been using). TURN OFF the oven and then stick the head lights in. Have fun!

 

[sir21]

I took out as much as I could and baked the rest. There was quite a few components in there left so no worries. I baked at 400.