The rear doors were super easy and I had both removed, wrapped, and reinstalled in less than an hour. The front passenger side wasn't too bad, but I couldn't fully detach the handle from the housing. I had to wrap it while it was hanging off the side of the door. The driver side was a bit of a PITA, since the handle has the push-button as well as physical door lock. I had to wrap both while they dangled from the side of the door. Also, since the door lock is recessed, I had to insert a small strip of vinyl to trace around the inside circumference of the recess, then wrap the exterior over the top of the opening (I'll post some photos of what I'm talking about later).
The install turned out very clean and professional looking. I'm beyond pleased with the results.
---------- Post added at 03:04 PM ---------- Previous post was at 01:20 PM ----------
---------- Post added at 10:06 PM ---------- Previous post was at 09:43 PM ----------
I used did the best I could with Lightroom's adjustment brush to bring the window glare back under control. I'll see if I can find a circular polarizer tomorrow.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.