snakeye
Member
- Location
- South Jersey
I been looking for pre-cut tints films or something similar on web for the back lights, but found no site that make them for FX35. Does it exist? I see many site carry G35. Any help will be appreciated.
Pre-cut tints films brake lights for 2010 FX35?
- Thread starter snakeye
- Start date
ThE Fx 45 BeAsT
Member
- Location
- Seattle
I can say that since the g35 have a more flatter light ( less curves) its easier for the fx the lights have more curves and can be more difficult even a pre cut might not work as well but you can get sheets of the tint and get it done.
- Location
- Westchester, New York
- Car
- 09 FX50
The tint will not sit correctly because of the contour. You should instead get them paint-tinted by a body shop
- Location
- Santa Clarita, CA
- Car
- 2005 FX45
You can go to most any tint shop and they could do it for you. It isn't very hard and I had mine done here in Socal at http://www.stickercity.com/
- Location
- Westchester, New York
- Car
- 09 FX50
He has a '10, it's even more difficult to tint with film than the older lights
- Location
- Santa Clarita, CA
- Car
- 2005 FX45
Ah I see, yea it would take some time and effort but it still could be done just like the headlights of the 1st gen were difficult too.
ThE Fx 45 BeAsT
Member
- Location
- Seattle
definitely with some time, I think with a sheet of tint and not some pre-cuts
I went to a professional vinyl shop hoping to have my taillights tinted too. In the end they couldn't do it with 1 piece of vinyl because of all the crazy curves. They said they can do with 2 pieces, but that would risk them peeling. So in the end I had to get a paint shop to tint them.
FXchris305
Member
- Location
- miami
- Car
- 2005 Honda S2000
try fly eyes .i was thinking about doing it to my fx. looks very easy to do and cheap . heres the link http://www.flyeyeskit.co.uk/ look at the video section to see how they install it.
ThE Fx 45 BeAsT
Member
- Location
- Seattle
notice those headlights are flat with not too many curves, try it on your fx and let know how it goes and that is if they have one available.
snakeye
Member
- Location
- South Jersey
I figure it not going to be easy to make one, because of the curves and bump of the lamp housing. I probably would get a roll of films work on it myself. I'll post it if I do. Thx for the reply all.
sobi6111
Member
- Location
- Kazakstan, Aktau
Pics?
I didn't do it yet :tongue (2): I plan on doing it but never got around to taking it to the shop.
Fire0nic3FX
Member
Front headlight tint looks cheap and ghetto. If you want black headlights get the inside painted.
You can't change the yellow side marker, the headlights would need to be opened up. That is unless you went and bought the euro headlights. Which is alot of $$$
You can't change the yellow side marker, the headlights would need to be opened up. That is unless you went and bought the euro headlights. Which is alot of $$$
