P0345 & p0340

[WiND DANCE]

Hey guys,My car stalled and died on Father's Day. Issues with Cam sensors


-Pulled the code P0345 Cam Sensor A bank 2.
-I replaced both Bank 1 & Bank 2 cam sensors with BWD Sensors.
-Made sure the connections were good and everything was bolted up.
-Tried to do the Ecu reset but I think it was unsuccessful-Cleared code via OBD Reader
-Started the car and the VCD, Slip, SES lights were on solid.
-Drive down the street and it was jumpy.


Should I proceed and change the crank position sensor as well? Anyone have any suggestions?




Oh btw the stupid tow truck driver didn't know I had the car in park when he was winching It onto the flatbed, only noticed after half the car was up.. Think it did any damage?

---------- Post added at 07:50 PM ---------- Previous post was at 06:07 PM ----------

I ran out and grabbed a Crank postion sensor and replaced that. No more code thrown after driving around the block.. hopefully this fixed it.

 

[Themechanic]

As long as he didnt tow it like that at all you should be ok. Nissan doesnt let some generic scanners read or erase some of their codes for some strange reason. Try disconnecting the battery to reset the light if the scan tool doesnt work.

 

[WiND DANCE]

FX is running good. Not sure if it was cause of the crank sensor

 

[Themechanic]

It could have possibly been that. Nissan had some maxima cam & crank sensors that were going bad so they redesigned them and suggested replacing all 3. Wich all look exactly like the fx ones. Plus theyre surrounded by plastic exposed to high heat so i woudnt doubt it was that. Also check your oil.

 

[WiND DANCE]

Thanks, I just did the oil last week. I double cheek the dip and the level is good. 2.5 days of driving and it's been good. Even got her to 17.3mpg in the city.

 

[SiMpLyMoDiFiEd]

I had same issues and I have replaced both cam position sensor, crank position sensor, altenator, battery and clean the cam windows and no luck seems to be worse.