Inner Tail Lights Angel Eyes add-on.

[la_fx35]

Those are bright LEDs. Looks good.

 

[ocal21]

That looks real good

 

[smijus]

Nice write-up Lucki.

 

[GetLuckiFX]

Thanks guys, been a while since I wrote one

 

[Cruiser]

Very nice Adam. You probably have some really steady hands.

 

[jdTrader]

Thank you for posting for the community!

 

[GetLuckiFX]

Very nice Adam. You probably have some really steady hands.

Thanks, I don't know if they are steady but def one of those mods where one cannot afford to make a mistake. My fingers did hurt the next day lol

 

[g0ldm4g3]

Oooooooooooo, but that avatar!

 

[GetLuckiFX]

:-D thanks for noticing, figured it is time to update the avatar as well

 

[J3FF3R$0N]

The halo kind of looks like a different red than the tails, is this the camera. do they match in person. Looks really cool

 

[GetLuckiFX]

The halo kind of looks like a different red than the tails, is this the camera. do they match in person. Looks really cool

Originally the rings were a bit more red. I tinted the rings slightly to make them darker and now it's pretty much the same, but camera still makes it look a bit off. Plus they were super bright, looked like brake was engaged, so tinting took care of the glare too.

 

[Stealth]

Had seen this in your garage but didnt realize you had done a write up on it. I might have to add this to my to do list. Nice work!

 

[Myis300]

Which lights did you use for the bumper reflectors

 

[GetLuckiFX]

First I went with the overpriced strips from
AutoZone, those burnt out after 3 months. Then got the strip off eBay, after a few weeks some LEDs started to flicker, dim and eventually died. Finally ended up with ones from vleds. Those seem to finally work and no issues so far. 12" strip is what I went with for two rows in each reflector.

Here is the link:

http://www.vleds.com/red-exterior-waterproof-led-strip-lights.html

 

[CALMOTION]

Can you remove the red reflector and install the 12 inch LED without removing the bumper..very nice work Thanks

 

[GetLuckiFX]

Can you remove the red reflector and install the 12 inch LED without removing the bumper..very nice work Thanks

Unfortunately no. Reflectors are held from the back by a small phillips screw, so in order to get them out, you'd have to remove the bumper.

 

[la_fx35]

^ :plus1: Yep, the little screw add much more time to remove the reflector removal.

 

[Myis300]

Thanks was it hard to remove the bumper

 

[GetLuckiFX]

It's actually easier than it seems. Just a few bumper clips, screws and bolts and you're in
I'm not sure if I posted bumper removal diagram in my garage of not, but just do a search for it and you will get a better idea.
The reflector itself takes a long time, getting it cut open with a dremell, then fitting the strips, sealing it all back together ...