How low until damage will occur on stock 20S

M

MB2702

Member
Location
san diego
I have BC coilovers on with OEM 20s and I am trying to find out how low I can go before any damage will occur. I have the front slightly in the wheel well and the drivers side is perfect with no camber, but the passenger side has a slight negative camber. Any reason that may happen only on one side? they are at the same measurements.

Also, can I go even lower if I were to want to without damaging any components?

Thanks
 
Get an alignment to put the camber where it should be. Is it rubbing the plastic on the fender? you may want to trim it and roll back the metal. It's likely already causing "damage" depending how low you are.
 
its not rubbing on anything cosmetic (but I will have to do that for the rear) but I just want to make sure that it wont cause damage to the steering or arm components or something like that. other than any rubbing, Im guessing that I can go as low at the fenders will allow? Am I wrong to assume that?
 
Rub or how low you can go its all depends on your stance. If your wheels are somewhat tuck in a bit behind the fender, you can lower more than if your wheel is flush with fender. I would highly recommend to roll your rear fender before your tire side wall gets cut up.
 
Going very low without rolling your fender will shred your tires like ribbons. I was there. Not pretty.
 
You must log in or register to reply here.
Back
Top