having problems with installing hid fogs.

[fx35_UCH]

hey guys I am in process of installing the 3000 jdm yellow HID kit and having
problem with removing the 2 10mm nuts inside the fender.. I tried everything but failed at every attempt. Can anyone assist me in this enigmatic and frustrating mod..

 

[StuLax18]

Inside the fender? Maybe you could start with posting pics of the nuts?

 

[fx35_UCH]

I am having problem with #5

 

[dopie]

you hafta remove the wheel well liner or kind of push it back so you can access the nuts this process would be alot easier if you remove your front 2 wheels and then remove the wheel well and then you can acces the nuts

 

[N2FX]

I didn't go that route. I went underneath the bumper. Its was a tight squeeze though.

 

[dopie]

it would be best to take the bumper off though no?

 

[jbaker1121]

You need to move the wheel well liner out of the way for those, so try angling your wheels for easier acess

 

[fx35_UCH]

thanks guys for your inputs. After hrs of trial and error I finally managed to lose the 10mm nuts. Unfortunately, one the ballast was defective so my attempt was wasted.. Urgh, talk about bad luck..

 

[KNFX]

yeah man, that sucks. for what its worth, its probably easiest to remove the front tires and remove the wheel wheel liner. Every time i've done it, I try to save some time/effort and try it without taking out the line and that just causes more trouble...

 

[jbaker1121]

thanks guys for your inputs. After hrs of trial and error I finally managed to lose the 10mm nuts. Unfortunately, one the ballast was defective so my attempt was wasted.. Urgh, talk about bad luck..

eBay brand? lol

 

[Chedman13]

I installed my new digital ballast HID kit without removing the front bumper. Rhino ramps or jack is all that is needed. Remove under panel and that's it.

Good luck