Fuji badge advice

It looks menacing all black, not thump at all. Chrome is for homies in the hood :tongue: I think blingy chrome is just so 90's. If I'm wrong, then maybe I should find a new job . . I'm a car designer :cool:
As far as the grill, black would be the way to go, cuz billet that big could belong on a Chevy or Ford full size. I would attempt to conceal it in black rather than create attention towards it. JMO
 
I'll shoot a couple more this weekend. Still need to take pix of the new damper & lightweight pulleys + belts, plus the new sub&amp custom install.

I eyeballed it - used the structural cross members of the grill and the license plate as references. You can see the cross members through the grill.
 
yeah, the lower trangles look even side to side, from dead on straight is it centered well between the 2 vertical inner support bars? height looks good. as long as it's centered well & straight it looks way better with it to me, especially on an otherwise bland billet, only like them at all with the emblem really, especially on the fx, might look good plain billet on a db9 or something... ...
 
I hear you. I did like it for more than two years - the clean, simple look. But only recently I got the idea in my head it was too flat and needed a focal point. I had the emblems from my engine cover and from the original grill so I just stuck them up there. All the reinforcement from this thread eliminated further hesitating.
 
Last edited:
Hey Jumbo I like the billet grill, I have the same but all blacked out. now I'd like to do a stock badgeless grill. good job man!
 
You must log in or register to reply here.
Back
Top