Front brake caliper mount inner nut replacement

[eJay]

Hey guys, so I just installed the H&R springs and during the process, I over-tightened the inner nuts of the front caliper mounts. These are the nuts that you have to hold onto while tightening/untightening the caliper mount bolts from the inner side of the wheel-well. The upper two nuts (one on each side) tighten fine but when I try to tighten the lower nuts, the bolt keeps on "tightening" without much force. I am wondering if I can replace these nuts without replacing the entire caliper mount. If I can, could someone tell me the size and location to get these hexagonal nut?

Thank you in advance!

 

[la_fx35]

They are called caliper bolt & guide pin. You can find them at AutoZone
http://www.autozone.com/autozone/pa...ilterByKeyWord=caliper+bolt&fromString=search

 

[eJay]

Thank you so much la_fx. Do I use one package for one caliper? So two pairs of pins/ bolts for one brake (one pair for top & one pair for the bottom)? Also, what's the recommended torque setting for these bolts?

 

[la_fx35]

I would replace both top and bottom as the kit comes as a set. The factory spec on the bolt is 34 ft lb. I normally just tighten by feel. be sure to use the right one as they're different in design.

 

[eJay]

Okay. I just wanted to make sure that one pack = one rotor mount. I just placed an order for two sets. Thank you again la_fx!

 

[la_fx35]

What you mean there is no AutoZone locally? Other parts store might have it too.

 

[eJay]

I placed a special order because they did not carry it in store It will be there in two days so I just have to go pick it up.

 

[la_fx35]

:top: Got it.

 

[Viperi]

uh o, i better take my tires off, i didnt hold that nut when i tightened the one from behind! ARG!