Panzer74
Member
- Location
- El Paso TX.
Look what El Paso has going on in October
This will be my first ever car show that I will be entering:eek.: As far as I know Im the only FX that is going to be in it. I have not seen any modded FX here in El paso. When I registered I was given a spot indoors in a "GOOD SPOT". Its the 4th car in from the entrance. I'm classed as a SUV-STREET-MOD so Im with the other SUV's but no FX's (1st or 2nd gen). Looking forward to showing off and representing the FX crowd. I still have lots to do to get her ready.
1. Black custom floor mats F/R/Cargo. The rear will have the Infiniti logo on the center hump in white thread. All mats will be black with wheat colored edges. The front will have Momo floor plates L/R
2. Momo black/ silver shift knob. The leather for the shifter boot is getting replaced with Black custom leather/ tan string that I'm having made.
3. Finish up in the 3m-DINOC carbon wrap (ashtray/ cup holder covers).
4. Get the scuffs out of the speaker cover. (Driver side)
5. Get a god detailing done. (nothing like BIG A here)
6.The Engine mods I posted before done
a: Plenum/ harness cover powder coated black chrome.
b: Blots for plenum and cover Bronze
c: Orange SAMCO hoses
d: Cables warped in Red 3m High temp tape.
7: Clear tails then smoke them.
8: Repaint the grill
9: A LITTLE HERE A LITTLE THERE:wink (2):
This will be my first ever car show that I will be entering:eek.: As far as I know Im the only FX that is going to be in it. I have not seen any modded FX here in El paso. When I registered I was given a spot indoors in a "GOOD SPOT". Its the 4th car in from the entrance. I'm classed as a SUV-STREET-MOD so Im with the other SUV's but no FX's (1st or 2nd gen). Looking forward to showing off and representing the FX crowd. I still have lots to do to get her ready.
1. Black custom floor mats F/R/Cargo. The rear will have the Infiniti logo on the center hump in white thread. All mats will be black with wheat colored edges. The front will have Momo floor plates L/R
2. Momo black/ silver shift knob. The leather for the shifter boot is getting replaced with Black custom leather/ tan string that I'm having made.
3. Finish up in the 3m-DINOC carbon wrap (ashtray/ cup holder covers).
4. Get the scuffs out of the speaker cover. (Driver side)
5. Get a god detailing done. (nothing like BIG A here)
6.The Engine mods I posted before done
a: Plenum/ harness cover powder coated black chrome.
b: Blots for plenum and cover Bronze
c: Orange SAMCO hoses
d: Cables warped in Red 3m High temp tape.
7: Clear tails then smoke them.
8: Repaint the grill
9: A LITTLE HERE A LITTLE THERE:wink (2):
Attachments
Last edited:
