Dropping advice needed

S

szj2020

Member
Location
Canada, QC
I just got my 22" rims installed. They are 22x10.5 et 25 with 305/35/22 on them.

front fits perfect, back sticks out approx 1/32". Is this "droppable". Anyone with same setup?

Thanks for advice

back.jpg


side.jpg
 
Psiclne said:
Yes its droppable.....but your gonna have to do some shaving.
Click to expand...

A LOT of shaving! fronts you will rub but you can't shave too much in the front so even after shaving you will still rub but as long as the underlying sheet metal is shaved then the tires will only be rubbing on the plastic trim. Same for the rear but you can shave a bit more there but you will still experience rubbing. That is a lot of offset plus wheel width in the rear!
 
Dr.2K said:
A LOT of shaving! fronts you will rub but you can't shave too much in the front so even after shaving you will still rub but as long as the underlying sheet metal is shaved then the tires will only be rubbing on the plastic trim. Same for the rear but you can shave a bit more there but you will still experience rubbing. That is a lot of offset plus wheel width in the rear!
Click to expand...


what about rolling? is there a difference? pros and cons
 
Some have rolled, but I personally would shave and grind as the sheet metal underneath the trim would still be there and in a full bottom out the metal may still have a chance to cut into the tire and specifically for the rear I would have to agree with Babaluwee. But the fronts not as much.
 
rims.jpg


in this pic it looks like 1/4 of the wheel is sticking out.......:eek:
 
You must log in or register to reply here.
Back
Top