B2 Auto Design V2 Spacers

P

per4m28

Member
Car
FX35 2010
Name
B
Hi all, Just fitted these B2 Auto Designs V2 Spacers on a 2010 FX35 they seem to be in very good quality and finish. Fitment was good on all 4 corners. We installed 15mm fronts and 20mm rears. I talked with Charles for a bit about sizing as I was looking for a flush fit and if he recommended a particular sizing on 2nd gen, but was unsure for 2nd gen for a flush fit. So I went 15/20 to be safe and according to the measurements taken I should of went with 25mm to get a more of a flush fit. 15mm in the front looked to be almost flush maybe a very slight poke if that I think to be exact its about 12-14mm to be dead on flush thats with a 50mm offset wheel as 2nd gens have. Rears were a bit tuck at 20mm exact flush probably would of been more 22-24mm IMO. Here are a few before and after pictures sorry about the angles taken.
 
Looks good maybe 25mm in the rear would have need ideal. But it looks good as it is right now
 
Looks good. Yeah, I think 25 mm rear would be flush flush. :smile (2);
 
I did 25mm in the rear and they are flush to a slight poke.
 
RIPnFX said:
I did 25mm in the rear and they are flush to a slight poke.
Click to expand...

RIPnFX yes I did read your post on the 25mm you installed but at the time I ordered this for some odd reason I couldnt find your post at the time or I would of ordered the 25mm and went with my measurements.
 
I would do 10-15mm in the front and either 20-25mm in the back. On my ride I went with 15mm front and 25mm rear and they sit flush with stock 21's.
 
You must log in or register to reply here.
Back
Top