Guess what I'm doing this weekend?
- Thread starter MTN FX
- Start date
- Location
- Los Angeles, CA
- Car
- 05 FX35 RWD
You must have received part of that stimulus package, huh? 
gchristopher9
Member
- Location
- Boston MA
that was ALMOST mine!
- Location
- Westchester, New York
- Car
- 09 FX50
....sending me that STB?
- Location
- Los Angeles, CA
- Car
- 05 FX35 RWD
Papers? Tell me more. You buy something?
- Location
- Dallas, TX
- Car
- 2007 FX35 RWD
I wonder if I get a stimulus check. Because of the state of the economy I actually don't owe any taxes this year. Last year it was like $30, but since I didn't make as much money all the breaks bring it down to 0.
- Location
- Southern California
it shouldn't take all weekend
you can probably be done before you finish a 6 pack lol
you can probably be done before you finish a 6 pack lol
- Location
- Dallas, TX
- Car
- 2007 FX35 RWD
Hardest part is getting the strut tower bolts off, from my experience.
Do you know what the torque specs tor the strut brackets and the allens for the bar?
- Location
- Dallas, TX
- Car
- 2007 FX35 RWD
Wow I just realized that I lost my service manual now with my HD crash, so I can't look it up. Personally, I just hand tightened them. Did that with the rear GTSPEC too, until I can go back and re-torque them.
- Location
- Santa Clarita, CA
- Car
- 2005 FX45
You don't need a torque wrench. Just hand tighten and it will fine. But after the initial install and tightening drive the FX around a bit and then retighten again for best results.
If I remember correctly oem brackets specs for are 35 ft/lbs. The Stillen bar is something like 25 ft/lbs. or just hand tighten. I've always went by these specs.
- Location
- Los Angeles, CA
- Car
- 05 FX35 RWD
That's great. Good luck!
A bit off topic but, if you benefit any from the stimulus package still save your dough. There will be taxes:: http://www.autoweek.com/article/20090311/CARNEWS/903119997
FXtion
Member
- Location
- sherman oaks, ca
enjoy.
- Location
- Los Angeles, CA
- Car
- 05 FX35 RWD
Do you have pics of the prop?
P
Psiclne
Guest
This sould only take a couple minutes......I believe Baba is correct on them specs.
sgvxcheese
Member
- Location
- Southern California
- Car
- infiniti fx 35
yea..dont do wat i did. I made the mistake of just guessing and did 40 for the tower bolts and now i can't take it off.