Installing pad questions

[carl292]

Hey fellas, picked up front and back Akebono Proacts and planning on getting the rotors turned. Can someone post up the torque specs for the calipers etc. Also, I planned on using some crc brake quiet on the back of the pads. Is it recommended? If so, just a thin layer or a lil thicker? Also, the pads came with some moly grease, am i better using that instead of the pics grease i picked up when greasing the slide pins and the clip area. I searched the write ups and didnt see anything, youtube had some, but i wanted to ask the trusted people here for a first [emoji2]

 

[la_fx35]

Here ya go. I have not use any of the lube/grease for years. The hardware kit is sufficient to keep the pad from moving.

 

[carl292]

Thanks la ! I don't care if they move, just don't want the squeal :D

 

[carl292]

Hey la oth pdfs are for rear. Do u have fronts, in the middle of it now

 

[la_fx35]

There are two PDFs attached in my earlier reply

 

[carl292]

There are two PDFs attached in my earlier reply

Must've saved them wrong on my end! Got the rotors turned and put in all new Akebonos Proacts, went for a ride to bed them and I can already feel that they a very good pad.... And no screeching so far