Window rolls up then down.

W

Waleedalot

Member
Location
Torrance, CA
I have an 05 Infiniti FX35. Window was broken and I had it replaced. Now there's a problem with the auto up feature. The window will roll up but when it closes, it rolls back a quarter of the way. If I don't use the auto feature, the window will not roll back when closed. The shop closed down so I'd like to do the repair myself.
 
Sounds like a possible problem with the pinch protection... maybe alignment or adjustment of the window.
 
i had this happen to me when i got my window broken into.

the body shop ordered aftermarket window, and the window was a lil degree off then the oem ones and that happend. so they ordered me a factory window and it works find.

and second it can be the regulator that is missed up also.
 
Quick question on this procedure. Do you have to remove the inner door panel (metal panel with about 8 screws) to get to the reset switch. or is it something you can get to after removing the outer door liner panel (interior panel w/window switch).
 
OK I did this procedure today after being annoyed with the window not rolling up properly, after repairing a door handle. after removing the door panel you'll find the reset button at the center of the door covered by a small circular piece of vinyl. uncover the reset button, follow those procedure in Jeff's pdf DIY post #4 of this thread and your done.
 
OK , did my driver door today , had a problem since installing the weathertechs , had to do it a few times to get it right . We shall see if it works long term...
 
I cant even see it till i post 10 times ... Offff

---------- Post added at 12:13 PM ---------- Previous post was at 12:12 PM ----------

Please someone reply to me i have this problem and cant see the limit setting procedure
 
Is there no other way to see that DIY PDF on how to reset the switch?
I've had my 2005 Infiniti FX45 since '08 - wish I had signed up for this forum sooner! Could have used a lot of this advice.
Today, I took apart my entire door (metal face included) and screwed everything up as the regulator and motor are now off track because when you take out the screws it seemed to move everything slightly off where it should be. I don't advise removing the metal part and disconnecting everything. :(
If by miracle, I can get it back together, I'd love to try the vinyl cover button trick... if...
Would someone be willing to email instructions?
 
You must log in or register to reply here.
Back
Top